FlashQ LightPix Labs Q20 III Manual Flash (ประกัน 1 ปี)

The Must-Have Flash Unit
With a guide number of 65.6′ at ISO 100, the Q20III has manual power selection from 1/64 to full power, runs on two separately available alkaline or rechargeable NiMH batteries, and will recycle to full power in six to seven seconds depending on the batteries in use. Only rechargeable NiMH batteries support USB-C charging.

All-New Diffuser Panel & Color Gel Holder
The upgraded Q20III flash is packed with a color gel holder to expand your possibilities. Easily attach and remove the gels in seven different colors to get the light color you’re looking for. The diffuser panel is another valuable addition to the Q20III body.

Detachable Transmitter Design
One of the flash’s clever features is the RF transmitter built into its removable foot and the receiver built into the body of the unit. By detaching the transmitter and mounting the flash head remotely on a light stand, you can adjust power and trigger it from the on-camera transmitter at distances up to 33′.

Manual Flash Power Control
The Q20III allows you set the flash output from 1/64 (minimum output) to 1/1 (maximum output). These seven steps of flash power ratios can be adjusted by two buttons.

Remote Triggering Power Level Adjustment
The Q20III functions like a typical on-camera flash while attached to the included shoe-mount FlashQ transmitter. Detaching the flash puts it into wireless mode allowing it to be used off-camera. Wireless triggering and power level adjustment can then be accomplished via the camera-mounted transmitter. The Q20III’s FlashQ System can support up to eight remote Q20III flashes simultaneously.

USB -C Charging
This third generation was developed with a USB-C interface to allow charging from standard USB power sources, such as your computer or USB adapters. It requires the use of two separately available rechargeable NiMH batteries on the light body. The transmitter can be conveniently charged via its USB-C port as well.

Rectangular Shape
The 4 x 2.3 x 1.1″ flash is easy to squeeze into tight spaces.

LED Video / Modeling Light
The Q20III features a 5500K LED light with seven output levels for use as a modeling light or as a video light with a high CRI of 95. The LED light outputs up to 60 lux at 3.3′ and has a 60-minute run time with NiMH batteries.

Tripod or Light Stand Mount
Built-in female 1/4″-20 threads allow the Q20III to be mounted on a tripod or light stand.

Tilting Head
The Q20III can tilt in 0, 45, 60, 75, and 90° click stops.

Compatibility
The Q20III is also compatible with other FlashQ triggers and flashes models, including the Q20 and Q20II units. Both USB-C ports on the flash body and transmitter support sync cord connection.